Lenovo 5110 Manual De Usuario
Chapter 9. Replacing FRUs
Important
Before you replace any FRU, read Chapter 2 “Safety information” on page 3. These precautions and
guidelines will help you work safely.
guidelines will help you work safely.
FRU replacements are to be done by trained service technicians only.
This chapter does not contain a removal and replacement procedure for all FRUs. Only the major FRUs
are documented.
are documented.
Adjusting the computer stand
Your computer comes with a stand that you can use to position the computer. Pull the stand open and adjust
the position of the computer at an angle of 10° to 35° as shown in the following illustration.
the position of the computer at an angle of 10° to 35° as shown in the following illustration.
CAUTION:
Make sure the angle is at least 10° from the vertical; otherwise, the computer might be unstable
and fall over.
Make sure the angle is at least 10° from the vertical; otherwise, the computer might be unstable
and fall over.
Your computer also supports UL (Underwriters Laboratories) certified 100 mm × 100 mm (3.94 inches × 3.94
inches) wall mounts. For proper mounting, use four screws of the following specifications: Diameter × Pitch
× Length: 4 mm × 0.7 mm × 10 mm (0.16 inch × 0.03 inch × 0.39 inch)
inches) wall mounts. For proper mounting, use four screws of the following specifications: Diameter × Pitch
× Length: 4 mm × 0.7 mm × 10 mm (0.16 inch × 0.03 inch × 0.39 inch)
Removing the computer stand
This section provides instructions on how to remove the computer stand.
To remove the computer stand, do the following:
1. Turn off the computer.
© Copyright Lenovo 2012
73