OKI ML6300 Manual De Usuario
Paper handling > 21
2.
Position the continuous forms supply directly below the
printer, no more than 3 cm left or right of the printer
paper path.
printer, no more than 3 cm left or right of the printer
paper path.
3.
Ensure the rear of the printer is close to and parallel with
the edge of the surface and at least 60 cm from any wall.
the edge of the surface and at least 60 cm from any wall.
F
EEDING
CONTINUOUS
FORMS
1.
Ensure that the printer is turned ON.
NOTE
If there is a cut sheet in the printer, eject it as described in
If there is a cut sheet in the printer, eject it as described in
2.
Ensure the Paper Type Lever (1) is set to Continuous
Forms.
3.
Adjust the Paper Thickness Lever to suit the paper.
NOTE
If the Paper Thickness Lever setting does not match the paper
being used, paper feeding and printing may not work properly.
If the Paper Thickness Lever setting does not match the paper
being used, paper feeding and printing may not work properly.
4.
Open the Rear Cover by gently pulling it out horizontally
to the end of its travel then swinging it upwards until it
locks into position.
to the end of its travel then swinging it upwards until it
locks into position.
1