OKI 407II Manual De Usuario

–  –

■

  Initializing Settings

Set the push switch as described below to initialize the 

setting information.

Push the switch for one to five seconds while running 

under normal operating mode. The green and red LEDs 

will flash with a regular pattern. After that, push the 

switch once again in that state to turn OFF both of the 

red and green LEDs. This will return the settings of 

the interface board to their default, or ex-factory, set-

tings. After the interface board has been initialized, the 

printer will automatically reboot itself.

■

  LED Display

 

Green :  Lights when other party connection is 

recognized as 00BASE-TX.

 

Red : 

Lights when packets are received.

Push Switch

LED

 

ON 

ON

 

OFF 

OFF

DIP-SW 

-

Command emulation (Ster Line mode)

Always ON

-

Should not be changed (Should be set to on)

-

Should not be changed (Should be set to on)

-

Sensor adjustment

Invalid

Valid

-

Should not be changed (Should be set to on)

-6

Handshaking  conditions  (conditions  for 

BUSY)

Offline  or  receive 

buffer full

Receive buffer full

-

Should not be changed (Should be set to on)

-

Should not be changed (Should be set to on)

-

Low-power consumption mode

Invalid

Valid

-0

Should not be changed (Should be set to on)

The factory settings of DIP switch are all on.

No. 1 2 3 4 5 6 7 8

No. 1 2 3 4

9 10

DIP-SW 1

DIP-SW 2