GCC Printers 21 Series Manual De Usuario
8-2
Accessing WebAdmin
In order to access the printer using WebAdmin, the printer must be attached to
an Ethernet network and running TCP/IP. If the printer has not been assigned
an IP address, consult Chapter 7 of this manual, “Networking the Elite 21
Series Printer.”
an Ethernet network and running TCP/IP. If the printer has not been assigned
an IP address, consult Chapter 7 of this manual, “Networking the Elite 21
Series Printer.”
WebAdmin can be accessed one of two ways. If you know the IP address of
the printer, you can type the address directly into the Address field of your web
browser. For example, if the printer’s IP address is 1.2.3.4, you would type in
the following in the Address field:
the printer, you can type the address directly into the Address field of your web
browser. For example, if the printer’s IP address is 1.2.3.4, you would type in
the following in the Address field:
http://1.2.3.4
If the IP address of the printer is not known, or if there are multiple GCC
printers on the network, you can also use the MAP (Management Access
Program) software included with the printer. This software is a Windows-based
utility which locates GCC printers on the network.
To use the MAP utility, run the MAP installer on the Elite 21 CD-ROM by
inserting the CD-ROM in the PC, opening the Network folder on the CD,
opening the MAP 3.72 folder inside this folder and double-clicking the
SETUP.EXE file icon. This will install the MAP program and include it on the
Programs menu of Windows.
printers on the network, you can also use the MAP (Management Access
Program) software included with the printer. This software is a Windows-based
utility which locates GCC printers on the network.
To use the MAP utility, run the MAP installer on the Elite 21 CD-ROM by
inserting the CD-ROM in the PC, opening the Network folder on the CD,
opening the MAP 3.72 folder inside this folder and double-clicking the
SETUP.EXE file icon. This will install the MAP program and include it on the
Programs menu of Windows.
Before running MAP, you should run the MAP Setup utility to set whether MAP
should look for printers using TCP/IP, IPX/SPX or both. The default setting is
for the utility to check both, however this can cause error messages to appear
if one or the other of the protocols is not enabled on your PC.
To run MAP, go to the Start button of Windows, then to Programs and down to
MAP. Select the MAP Setup item in the MAP folder. This will open a window as
shown on the next page:
should look for printers using TCP/IP, IPX/SPX or both. The default setting is
for the utility to check both, however this can cause error messages to appear
if one or the other of the protocols is not enabled on your PC.
To run MAP, go to the Start button of Windows, then to Programs and down to
MAP. Select the MAP Setup item in the MAP folder. This will open a window as
shown on the next page: