GCC Printers 21 Series Manual De Usuario
10-10
1.
Check the printer’s display to make sure
the unit is in the Ready mode.
the unit is in the Ready mode.
Switch off the printer’s power switch at the
front of the unit and unplug the printer’s AC
power supply from its outlet.
front of the unit and unplug the printer’s AC
power supply from its outlet.
Caution: The fusing unit of the printer will
be very hot directly after printing. Wait at
least 30 minutes to let the fuser cool down
before servicing the fuser.
be very hot directly after printing. Wait at
least 30 minutes to let the fuser cool down
before servicing the fuser.
2.
Squeeze the latch at the upper left of the
rear panel and pull towards you to open the
rear cover of the printer.
rear panel and pull towards you to open the
rear cover of the printer.
If you are using a paper cassette extended
past the Letter/A4 setting, remove the
cassette before opening the rear cover.
past the Letter/A4 setting, remove the
cassette before opening the rear cover.
Replacing the Fuser
The Fuser is used for fixing toner onto the paper. It should be replaced after approximately 200,000
sheets have been printed. Depending on operating conditions, however, the fuser may need to be
replaced before or after that interval is reached. Instructions for replacement of the fuser are as
follows:
sheets have been printed. Depending on operating conditions, however, the fuser may need to be
replaced before or after that interval is reached. Instructions for replacement of the fuser are as
follows: