Zebra Technologies P1043301-005 Manual De Usuario

Hardware Troubleshooting
Unable to Configure Device

P1043301-005  

11/21/13

To assign an IP address to a ZebraNet print server using ZebraNet Bridge, you must be on the 
same subnet. If ZebraNet Bridge has Multicast enabled, you may be able to view the ZebraNet 
print server on another subnet, but you will not be able to configure the device.

The ZebraNet print server may be set up and managed using HP JetAdmin or HP Web 
JetAdmin products.

 shows error messages that may appear on the control panel.

The wireless radio card is not inserted at all or is not fully seated.

The wireless radio card is present but cannot log on to the network.

The wireless radio card is present and associated with the access 
point, but it has not been authenticated by the authentication server.

The wireless signal strength has dropped below the poor signal 
threshold value, which is set through the Wireless Setup web page 
(see 

).

Note • The poor signal setting affects when you see the 

 warning, but it does not affect whether 

your printer will be able to associate with your network at a 
low signal strength.

WLAN card is not configured properly. Contact your Zebra reseller 
for assistance.

The WLAN country code has not been configured. 

Use the 

Up

 and 

Down

 arrows to select the appropriate country 

code. 

Press 

Set

 to save the country code.