Zebra Technologies P1043301-005 Manual De Usuario

Configuration of Wireless Securities

11/21/13

P1043301-005 

You may configure your printer for wireless operation in the following ways:

Through the Network Setup Wizard.  The Network Setup Wizard is part of the 
ZebraNet™ Bridge Enterprise utility. The Network Setup Wizard writes a script for you. On 
the last screen of the wizard, you may choose to send the script directly to your printer, or you 
may choose to save the script to a file. The saved file has several purposes:

• The file can be sent to the printer through any available connection (serial, parallel, USB, 

or wired print server).

• The file can be resent to the printer after the network settings have been restored to factory 

defaults.

• The file can be sent to multiple printers that will use the same network settings.

The ZebraNet Bridge Enterprise utility resides on the User CD for your printer and is available 
through 

1.2.5 or later is 

required to configure the printer correctly for use.

Through ZPL script that you write.   Use the ^WX command to set the basic parameters 
for security type. You can send the command through any available connection (serial, 
parallel, USB, or wired print server). 

Refer to the Programming Guide for ZPL, ZBI, Set-Get-Do, Mirror, and WML for more 
information. A copy of the manual is available at 

User CD that came with your printer.

Through Set/Get/Do (SGD) commands.   Begin with wlan.security to set the 
wireless security type. Depending on which security type that you select, other SGD 
commands will be necessary to specify other parameters. You can send the commands through 
any available connection (serial, parallel, USB, or wired print server). 

Refer to the Programming Guide for ZPL, ZBI, Set-Get-Do, Mirror, and WML for more 
information. A copy of the manual is available at 

 or on the 

User CD that came with your printer.

Important • A wireless option board must be installed on your printer before you can 
configure the printer to communicate using a wireless radio card. See 

 to determine if your printer has a wireless board. See 

Note • To configure wired and wireless print servers on the same printer, run the program 
once for each print server, creating a script for the wired print server and another for the 
wireless print server.

Note • With printers running APL-I, APL-D, or EPL firmware, the only way to configure 
wireless settings is through SGD commands.