Zebra Technologies P1043301-005 Manual De Usuario
Getting Started
Defaulting ALL Print Servers
Defaulting ALL Print Servers
76
P1043301-005
11/21/13
Using ZebraNet Bridge
ZebraNet Bridge may be used default the print server to factory settings. Refer to the ZebraNet
Bridge Enterprise User Guide for more detailed information.
Bridge Enterprise User Guide for more detailed information.
Using a ZPL Command
Issue the ZPL command shown immediately below or refer to the ZPL II
®
Programming
Guide for ZPL II, ZBI 2, Set-Get-Do, Mirror and WML for further details.
^XA^JUN^XZ
Defaulting the ZebraNet 10/100 Print Server on the 105SL, S4M,
PAX4, and External Devices
PAX4, and External Devices
The
Test
button is accessed via a small recessed hole on the back of the external ZebraNet
10/100
). To press the
Test
button, you need to
insert something small into the hole, like the end of a paperclip.
For the internal ZebraNet 10/100
Print Server device, the
Test
button is located on the back of
printer.
To default the ZebraNet 10/100
Print Servers to factory settings using the Test
button, complete these steps:
1.
Turn off (O) the printer.
2.
With the printer turned off, press and hold the
Test
button on the ZebraNet 10/100
Print
Server device and turn on (l) the printer.
3.
The status indicator tells you when ZebraNet 10/100
Print Server has been reset to factory
defaults, as follows:
•
If an active network cable is connected to the ZebraNet 10/100
Print
Server,
the
status
indicator turns solid green.
•
If there is not an active network cable connected to the ZebraNet 10/100
Print
Server,
the status indicator flashes red.
4.
Release the
Test
button.
Note • To download a copy of either of the guides mentioned above, visit the Zebra web site
at:
at:
.
Note • You must have an active network cable connected to the external ZebraNet
10/100
10/100
Print Server device to default the device using the
Test
button.