Zebra Technologies TTP 8000 Manual De Usuario
![Zebra Technologies](https://files.manualsbrain.com/attachments/a78f49d565a2596a8b31f4240e25fed2998da2a0/common/fit/150/50/2656e56263d759e2c7910989c000585d7bce0fb5d50f1f63705e38675fa7/brand_logo.gif)
Programming
Software Command Syntax
Software Command Syntax
36
P1003638-003
TTP 8000 Technical Manual
10/19/2009
Software Command Syntax
The commands in this section are grouped after what they do, and these groups are sorted in a
theoretical usage sequence. It starts with commands for specifying the printed page — through
text-and-graphics commands — to cut-and-present commands. System and status commands
are presented at the end.
theoretical usage sequence. It starts with commands for specifying the printed page — through
text-and-graphics commands — to cut-and-present commands. System and status commands
are presented at the end.
Black Mark (Top-Of-Form) Commands
See also
.
Refer to TTP 2000 Technical Manual (Zebra part number P1002902) for correct format.
Looks for a black mark, measures the contrast of the mark and sets parameter n51 to a suitable
value for the detected voltage, then reverses to the start position.
value for the detected voltage, then reverses to the start position.
To make the calibration permanent, send <ESC>&<4>, store parameter values.
ESC # is available in hardware revision B or higher.
In black mark mode, an ESC Z
starts looking for a black mark at the current position and
continues for one page length. If no black mark is found, the printer stops and bit 3 in status
byte 2 is set to 1 (See ESC ENQ 6
byte 2 is set to 1 (See ESC ENQ 6
).
When black mark mode is disabled, ESC Z will perform a form feed without cut (disregarding
the setting of parameter
the setting of parameter
).
ESC #
Calibrate Blackmark Sensor
Hex
decimal
Note •
Be sure to first set up the length of the black mark and the distance between two black
marks in the parameter setup.
ESC Z
Go to next Top of Form
1B 5A
Hex
27 90
Decimal