Brother 1900 Manual De Usuario

52

• This message appears if the text is 

longer than 3’ 3 1/3” (1 meter) when 
you try to print.

• Shorten the text to less than 3’ 

3 1/3” (1 meter) before trying 
to print.

• This message appears if the Length 

function is used to set a label 
length that is less than 1.6” (4.0 
cm) or more than 11.8” (30.0 cm).

• Set the label length between 

1.6” (4.0 cm) and 11.8” (30.0 
cm). 

• This message appears if the Tab 

Length function is used to set a tab 
length that is more than 11.8” 
(30.0 cm).

• Set the tab length so that it is 

less than 11.8” (30.0 cm).

This message appears if the number 
of lines in the text is greater than the 
maximum number of lines possible 
for the installed tape.

Reduce the number of lines or 
install a tape of greater width.

This message appears if you try to 
store a text file after the maximum 
number of characters has already 
been stored in the memory.

Delete an unwanted file to make 
room for the new one.

This message appears if you try to 
recall or delete a text file from the 
memory when none are stored.

Store a text file first.

This message appears if you try to print 
a label or feed the tape when no tape 
cassette is installed.

Install a tape cassette and try 
again.

This message appears if the installed 
alkaline batteries are about to run 
out.

Replace the batteries or use the 
AC adaptor.

This message appears if there is a 
problem with the machine’s read 
only memory.

Turn off the machine, and then 

while holding down 

c and 

R, turn the machine back on. 

Contact your service representa-
tive.