Bixolon SRP-270 Manual De Usuario

 

 
Lubrication and application adhesive plays an important role in maintaining this printer at its initial 
performance level, throughout a long product life as well as preventing potential troubles. Make sure to apply 
the specified lubricants or adhesive in the appropriate amounts at the specified intervals. 
 
8-4-1 Lubricant Requirements 
 
Before applying the lubricants during an assembly or disassembly procedure, be sure to first thoroughly 
clean the part to be lubricated. For details on lubrication. 
 
* Lubrication Classes 
Concerning the lubrication interval, lubrication should be performed periodically according to the lubrication 
classes described below. If lubrication becomes deficient due to cleaning, disassembly or parts replacement, 
be sure to lubricate the required part regardless of the lubrication interval. 
 

A: Lubrication every 6 months. 
B: Lubrication after on overhaul or every 1 million lines 

 
 
8-4-2 Lubricant Types 
 
The type of oil used greatly influences performance and durability, and special attention is required to its low 
temperature characteristic. Consequently, the oils to be used with this printer are specified by us on the basis 
of the result of the thorough analyses of technical data for many types of oils and various experiments. 
2 types of oils to be used with this printer are HG-31S, G 948P. 
 
 
8-4-3 Lubrication Points 
 

No 

No Lubrication Point 

Oil type 

1 
2 
3 
4 
5 
6 
7 
8 

Outer periphery of shaft hold roller 
Contact point between cam of head carriage and ribbon frame 
Contact point between shaft ribbon frame and lever cold change 
Contact point between spring ribbon feeder and ribbon feeder 
Outer periphery of shaft head carriage 
Contact point between solenoid plunger and spring solenoid 
Outer periphery of all gears 
Outer periphery of shaft head guide 

HG-31S 
HG-31S 
HG-31S 
HG-31S 
HG-31S 

G948P 

HG-31S 
HG-31S 

 
* Precautions on lubrication 
Never apply lubricant to Gear Ratchet or outer periphery of Rubber Roller. 
If lubricant has accidentally been applied to these parts, clean them with alcohol. 
 
 
8-4-4 Adhesive Application Requirements 
 
To prevent from screws getting loose by various vibration while transporting the printer, adhesive should be 
applied after tightening screws. When performing disassembly or parts replacement. 
 
 
8-4-5 Adhesive types 
 
The adhesive type for use with this printer : Screw lock 
 
 
8-4-6 Adhesive Application Points 
 

No 

Adhesive Application Point 

Adhesive Type 

12 

Volume resistance adjustment of main PCB 

Screw lock