DELL PP05XB Manual De Usuario

Descargar
Página de 190
152
Appendix
If you notice problems, such as skipping, with the playback quality of your CDs or DVDs, try cleaning 
the discs.
1 Hold the disc by its outer edge. You can also touch the inside edge of the center hole.
 
NOTICE: 
To avoid damaging the surface, do not wipe in a circular motion around the disc.
2 With a soft, lint-free cloth, gently wipe the bottom of the disc (the unlabeled side) in a straight line 
from the center to the outer edge of the disc.
For stubborn dirt, try using water or a diluted solution of water and mild soap. You can also purchase 
commercial products that clean discs and provide some protection from dust, fingerprints, and 
scratches. Cleaning products for CDs are also safe to use on DVDs.
FCC Notices (U.S. Only)
FCC Class B
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in 
accordance with the manufacturer’s instruction manual, may cause interference with radio and television 
reception. This equipment has been tested and found to comply with the limits for a Class B digital 
device pursuant to Part 15 of the FCC Rules. 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: 
1 This device may not cause harmful interference. 
2 This device must accept any interference received, including interference that may cause undesired 
operation. 
 
NOTICE: 
The FCC regulations provide that changes or modifications not expressly approved by Dell Inc. could void 
your authority to operate this equipment. 
These limits are designed to provide reasonable protection against harmful interference in a residential 
installation. However, there is no guarantee that interference will not occur in a particular installation. If 
this equipment does cause harmful interference with radio or television reception, which can be 
determined by turning the equipment off and on, you are encouraged to try to correct the interference by 
one or more of the following measures: 
Reorient the receiving antenna.
Relocate the system with respect to the receiver.
Move the system away from the receiver.
Plug the system into a different outlet so that the system and the receiver are on different branch 
circuits. 
If necessary, consult a representative of Dell Inc. or an experienced radio/television technician for 
additional suggestions.