IBM 6578 Manual De Usuario
2.
Press down on the tab, slide the bracket back and lift up.
Power supply removal
1.
Remove the CD-ROM drive (see “CD-ROM drive removal and
replacement” on page 60).
replacement” on page 60).
2.
Remove the two screws that secure the power supply to the front of the
chassis. Remove the two screws that secure the power cord plug to the
back of the chassis.
chassis. Remove the two screws that secure the power cord plug to the
back of the chassis.
3.
Locate the two tabs that secure the CD-ROM drive bracket to the back of
the power supply. Push in the two tabs and remove the bracket.
the power supply. Push in the two tabs and remove the bracket.
4.
Lift out the power supply and plug.
Components of the riser card
The following illustration shows the location of PCI connectors on the riser
card. The Ethernet disable jumper pins (as seen in the diagram below) are
numbered as follows:
card. The Ethernet disable jumper pins (as seen in the diagram below) are
numbered as follows:
Chapter 2. Types 6568/6569/6648/6649
65