Acer Veriton 3500G Manual De Usuario

83

The following questions are possible situations that may arise during 
the use of your computer and each is followed by easy answers and 
solutions to the situation.

Q:  I pressed the power switch but the system did not boot up.

A:  Check the LED located beside the power switch.  

If the LED is not lit, no power is being applied to the system.  Do any of 
the following:

•

Check if the voltage selector switch located on the rear panel of 
the computer is set to the correct voltage.

•

Check if you plugged the power cable properly into an electrical 
outlet. 

•

If you are using a power strip or AVR, make sure that it is plugged 
in and turned on. 

If the LED is lit, check the following: 

•

Is a nonbootable (nonsystem) diskette in the floppy drive?  If yes, 
remove or replace it with a system diskette and press Ctrl + Alt + 
Del to restart your computer. 

•

The operating system files may be damaged or missing. Insert the 
startup disk you created during Windows setup into the floppy 
drive and press Ctrl + Alt + Del to restart your computer.  This will 
automatically diagnose your system and make necessary fixes. 
However, if the diagnostic utility still reports a problem, then you 
may have to perform the recovery process to restore your system 
to its original default factory settings. 

Note:  For more information about recovering your system, refer 
to page 80. 

VT3500series_EN.book  Page 83  Tuesday, April 16, 2002  11:24 AM