GE 350 Manual De Usuario

 

 

 

 

g

 

 

 

 

The GE (General Electric) Digital Energy™ ML Series UPS, an uninterruptible power supply, protects 

your equipment from all forms of power interference, including complete power failures. 

 

 

 

 

•

 

  RISK OF ELECTRICAL SHOCK. The UPS contains batteries. The 

appliance outlets may be electrically live, even when the UPS is disconnected from the 

mains. 

 

•

  The UPS contains potentially hazardous voltages. Do not open the UPS, there are no 

user serviceable parts inside. 

 

•

  Apart from battery replacement on the ML 350/500/700 models, all maintenance and 

service work should be performed by qualified service personnel. 

 

•

  Always isolate the UPS from the mains during battery replacement. 

 

 

•

  No liability can be accepted for any transport damage when the equipment is shipped in non-

original packaging. 

 

•

  Before storing, charge the batteries for at least 24 hours. 

 

•

  Store the UPS in a dry location, storage temperature must be within -20 +45 

°

C. If the unit is 

stored for a period exceeding 3 months, optimal battery lifetime is obtained if the storage 

temperature does not exceed 25

°

C. Be sure that the UPS is switched off, and that no cable is 

connected to the interface port. 

 

•

  If the unit is stored for a period exceeding 3 months, the batteries must be recharged 

periodically. Connect the unit to a wall outlet for a period of approx. 48 hours, minimum every 3 

months. 

 

 

The shipping box contains a Digital Energy™ ML Series UPS, a power cord, a computer interface 

cable, a CD ROM and this manual. After unpacking, inspect the UPS for damage. If you find any damage 

please immediately notify the carrier and place of purchase. 

 

IMPORTANT: 

Before making any connection and switching on the Digital Energy™ ML Series UPS, please check the 

following conditions: 

 
 

•

  your mains supply is 220 - 240 Volts and 50 Hz, and 

 

•

  the total power demand of the connected equipment does not exceed the rated output power of 

the UPS (indicated on the rear panel). 

 

 
 

•

  The UPS is intended to be used in normal domestic and office situations. 

 

•

  Protect the UPS, according to the wiring rules, with a 16A D-type fuse. 

 

•

  The UPS must be powered from a single phase grounded wall outlet. Do not use extension 

cords. 

 

•

  Avoid locations that are excessively humid, near water, near heat sources or in direct sunlight. 

 

•

  The ambient temperature should not exceed 40

°

C. Optimal battery lifetime is obtained if the 

ambient temperature does not exceed 30

°

C. 

 

•

  It is important that ventilation air can move freely around and through the unit. Do not block the 

air vents. 

 

•

  Do not plug appliances such as electric heaters, toasters and vacuum cleaners into the UPS. 

The UPS output can be used only for electronic loads such as computers and 

telecommunications equipment. 

 

•

  Be careful when connecting laser printers: be sure that the demanded power does not exceed 

the capacity of the UPS.