GE GEK-106465A Manual De Usuario

38 

CIO Remote CAN Digital I/O Module 

  GEK-106465A 

These are the logic signals associated to the contact output reset, which produce the reset of those signals previously 
configured as Latched. The status of these signals is obtained at Actual > Status > Contact Outputs Resets > 
Board X, being X the corresponding I/O board. The name of these outputs is the same for the mixed and supervision 
boards, the only difference will be the slot where the output is located in the relay (slot F, G, H or J). These signals 
can be configured at Setpoint > Relay Configuration > Outputs > Contact Output Reset 

 TABLE  5-5 CONTACT OUTPUT RESETS 

CONT OP RESET_X_01  

CONT OP RESET_X_02  

CONT OP RESET_X_03  

CONT OP RESET_X_04  

CONT OP RESET_X_05  

CONT OP RESET_X_06  

CONT OP RESET_X_07  

CONT OP RESET_X_08  

 

These signals are associated to the different I/O boards. There are internal signals that provide information about the 
status of these boards, indicating whether there is any anomaly in the board, or whether the board is not available in 
the relay according to the relay model. This information can be accessed at Actual > Status > IO Board Status. 

TABLE  5-6 I/O BOARD STATUS 

BOARD F STATUS 

BOARD G STATUS 

BOARD H STATUS 

BOARD J STATUS