Brunton 7.5 Manual De Usuario

Descargar
Página de 18
5
the unit is being charged the green LED’s will remain illuminated until the battery pack 
is fully charged.
SPECIFICATIONS
 
IX. Battery Supply 
X. Charge Input Jack 
• The inlet will accept any 2.5 mm by 5.5 mm  barrel jack. 
• Charge input is rated for 11V DC to 16V DC. 
 
 XI. FCC 
This device complies with Part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) This device may not cause harmful interference, and (2) this 
device must accept any interference received, including interference that may cause 
undesired operation. 
Note: 
This equipment has been tested and found to comply with the limits for a Class B digi-
tal device, pursuant to part 15 of the FCC Rules. These limits are designed to provide 
reasonable  protection  against  harmful  interference  in  a  residential  installation.  This 
equipment generates, uses and can radiate radio frequency energy. If not installed 
and used in accordance with the instructions, it may cause harmful interference to 
radio communications. However there is no guarantee that interference will not occur 
Internal Battery Type
Lithium Iron Phosphate (LiFePO
4
)
Internal nominal battery Voltage
12.8 Volts
Internal battery capacity
5.6  Amp  Hours    for  Solo  7.5  &  12.8  Amp  Hours  for 
Solo 15
Expected cycle life to 70% of original capacity 1000 cycles
Current Rating
3 Amps nominal, 5 Amps peak
Wall Transformer
Input Voltage
110 Volt AC
Output Voltage
16 Volt
Output Current
3.36 Amps
Power
54 Watts