3com 3C16020 Manual De Usuario
3
C
ONFIGURING
T
HE
M
ANAGEMENT
M
ODULE
You must configure the SuperStack II UPS Management Module
before you can use it. The Management Module has a
configuration program that you can access by connecting the
module to a terminal or a computer with a terminal emulation
program.
before you can use it. The Management Module has a
configuration program that you can access by connecting the
module to a terminal or a computer with a terminal emulation
program.
Before You Start
Make sure you contact your network administrator for the
following values: IP address, Netmask (subnet mask), and Default
Gateway. For the Token-Ring model, you also need the operating
speed of the Token-Ring network (4 Mbps or 16 Mbps). Write
these values down for future reference.
following values: IP address, Netmask (subnet mask), and Default
Gateway. For the Token-Ring model, you also need the operating
speed of the Token-Ring network (4 Mbps or 16 Mbps). Write
these values down for future reference.
To use the configuration screens for the Management Module,
you need:
you need:
■
A serial cable (see Appendix A)
■
A terminal with an RS-232 serial port, or a PC with a terminal
emulation program such as Windows Terminal®
emulation program such as Windows Terminal®
The serial line should be set to 9600 baud, No parity, 8 bits, and 1
stop bit. The configuration program always runs at these settings.
stop bit. The configuration program always runs at these settings.
Local Configuration
To connect the module to the terminal and start the configuration
program:
program:
1 Plug the male end of the serial cable into the serial port labeled
“TERM.”