Panasonic A4P Series Manual De Usuario

101

<Remarks>
Don't disconnect the console from the driver between                      to                     .
Should the connector is pulled out, insert it again and repeat the procedures from the beginning.

<Note>
If the error display repeats frequently, check the broken cable, disconnection of the connector, 
misoperation due to noise or failure of console.

Initialization of EEPROM 
of the console starts.

Copying completes normally.

Error display

To move to the next process, press        .

The positioning parameter is copied 
from the servo driver into the 
console and the positioning 
parameter is written into EEPROM 
(console).

The servo parameter and driver 
type code are copied from the servo 
driver into the console and the 
driver type code of the servo 
parameter is written into EEPROM 
(console).

<Remarks>
If error is displayed, repeat 
the procedures  from the 
beginning.
Press        for releasing error.

Starting from initial LED status, Press        six time after pressing       , then press              , 

to make a display to

Press       to call for 

     EXECUTION DISPLAY of

Keep pressing         until 

the console display (LED)

changes to                       .

“      ” increases by 

pressing        (approx. 3sec) 

as the left fig. shows.

When you have finished the copy, press        to return to                                  .