Panasonic PT-LB90U Manual De Usuario
Care and Replacement
Maintenance
50 -
E
NGLISH
Attach the lamp unit cover and tighten the 2 lamp unit cover fixing screws securely
5 )
with a Phillips-head screwdriver.
Connect the power cord to a wall outlet.
Connect the power cord to a wall outlet.
6 )
Press the POWER button and the projection starts.
7 )
Remarks
If
z
INITIAL START UP in the PROJECTOR SETUP menu is set to ON, the projector starts projecting when the
Press the MENU button to display the main menu and press▲▼buttons to scroll to
8 )
the PROJECTOR SETUP menu.
Press the ENTER button to select the PROJECTOR SETUP menu and
Press the ENTER button to select the PROJECTOR SETUP menu and
9 )
press▲▼buttons to select LAMP RUNTIME.
Press and hold the ENTER button for approximately 3 seconds.
Press and hold the ENTER button for approximately 3 seconds.
10 )
The
z
LAMP RUNTIME confirmation screen is displayed.
LAMP RUNTIME
LAMP RUNTIME RESET.
OK
CANCEL PRESS ANY OTHER BUTTON
PRESS BUTTON
Note
If any button other than the
z
POWER button is pressed, the LAMP RUNTIME screen disappears and the lamp
runtime is not reset. (Repeat from step 8 again).
Press the POWER button.
11 )
After the lamp goes off, projection stops and the
z
POWER button lights in red, then disconnect the power
plug.
The lamp runtime is reset to “0”.
12 )