Panasonic TQBJ0349 Manual De Usuario
Technical Information
ENGLISH -
85
Appendix
REMOTE IN terminal
Using the [REMOTE IN] terminal provided on the connection terminals of the main unit, it is possible to operate
the projector from a control panel etc. furnished in a distant location where infrared remote control signal cannot
be received.
J
Pin assignments and control
D-Sub 9-pin (Outside view)
Pin No.
Signal name
Open (H)
Short (L)
GND
—
GND
POWER
OFF
ON
RGB1
Other
RGB1
RGB2
Other
RGB2
VIDEO
Other
VIDEO
S-VIDEO
Other
S-VIDEO
DVI-D
Other
DVI-D
AV MUTE
OFF
ON
RST/SET
Controlled by
remote control
Controlled by
external contact
Attention
Be sure to short-circuit Pins
z
and when controlling.
When pin
z
and pin are short-circuited, the following buttons on the projector's control panel and on the remote control
cannot be used.
<POWER (
)> button, <AV MUTE> button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either.
When pin
z
and pin are short-circuited and then any one of pins to is short-circuited to pin , the following buttons
on the projector's control panel and on the remote control cannot be used.
<POWER (
)> button, <INPUT SELECT> buttons (RGB1, RGB2, DVI-D, VIDEO/S-VIDEO, NETWORK, HDMI),
<AV MUTE> button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either.
z
Æ
page 66) is set to
“STANDARD”.
External control
ON
VIDEO
S-VIDEO
LAMP
Remote control
Remote control/External control
Standby
RGB1
RGB2
DVI-D
Control panel located in a different room
Projector set up in a meeting room