NEC M260X Manual De Usuario

115

7. Maintenance

This section describes the simple maintenance procedures you should follow to clean the filters, the lens, the cabinet,
and to replace the lamp and the filters.

1 Cleaning the Filters

The air-filter sponge keeps dust and dirt from getting inside the projector and should be frequently cleaned. If the filter
is dirty or clogged, your projector may overheat.

NOTE: The message for filter cleaning will be displayed for one minute after the projector is turned on or off. When the message is

displayed, clean the filters. The time to clean the filters is set to [OFF] at time of shipment.

To cancel the message, press any button on the projector cabinet or the remote control.

The two-layer filter on the projector improves cooling and dust-proof capabilities compared with the conventional
models.
The outsides (intake side) of the first and second layer filters remove dust.
To clean the filter, detach the filter unit and the filter cover.
Filter removal procedure is different depending on the model.

CAUTION

• Before cleaning the filters, turn off the projector, disconnect the power cord and then allow the cabinet to cool.

Failure to do so can result in electric shock or burn injuries.

[M350X/M300X/M260X/M230X/M300W/M260W]
1. Push the button to release the filter unit and pull it out.

2. Remove the filter cover.
The filter cover is fixed at six separate mounting points.
Bow the filter cover by pushing the notch slightly until it re-

leases.

3. Remove the four filters and use a vacuum cleaner to

vacuum all the dust inside.

Get rid of dust in the accordion filter

NOTE:

• Whenever you vacuum the filter, use the soft brush attachment to

vacuum. This is to avoid damage to the filter.

• Do not wash the filter with water. Doing so can result in filter clog-

ging.

WIRELESS

WIR

Notch

Filter unit

Filter cover

Button