Compaq 4000N Manual De Usuario
Appendix A Error Messages and Codes
Compaq Personal Computers
Changed - September 1997
A-6
A.10
DISKETTE DRIVE ERROR MESSAGES (6xx-xx)
Table A–9. Diskette Drive Error Messages
Table A-9.
Diskette Drive Error Messages
Message
Probable Cause
Message
Probable Cause
6xx-01
Exceeded maximum soft error limit
6xx-20
Failed to get drive type
6xx-02
Exceeded maximum hard error limit
6xx-21
Failed to get change line status
6xx-03
Previously exceeded max soft limit
6xx-22
Failed to clear change line status
6xx-04
Previously exceeded max hard limit
6xx-23
Failed to set drive type in ID media
6xx-05
Failed to reset controller
6xx-24
Failed to read diskette media
6xx-06
Fatal error while reading
6xx-25
Failed to verify diskette media
6xx-07
Fatal error while writing
6xx-26
Failed to read media in speed test
6xx-08
Failed compare of R/W buffers
6xx-27
Failed speed limits
6xx-09
Failed to format a tract
6xx-28
Failed write-protect test
6xx-10
Failed sector wrap test
--
--
600-xx = Diskette drive ID test
608-xx = Diskette drive write-protect test
601-xx = Diskette drive format
609-xx = Diskette drive reset controller test
602-xx = Diskette read test
610-xx = Diskette drive change line test
603-xx = Diskette drive R/W compare test
694-00 = Pin 34 not cut on 360-KB drive
604-xx = Diskette drive random seek test
697-00 = Diskette type error
605-xx = Diskette drive ID media
698-00 = Drive speed not within limits
606-xx = Diskette drive speed test
699-00 = Drive/media ID error (run Setup)
607-xx = Diskette drive wrap test
A.11
SERIAL INTERFACE ERROR MESSAGES (11xx-xx)
Table A–10. Serial Interface Error Messages
Table A-10.
Serial Interface Error Messages
Message
Probable Cause
Message
Probable Cause
1101-01
Port test, UART DLAB bit failure
1101-12
Port test, DRVR/RCVR cntrl. signal failure
1101-02
Port test, line input or UART fault
1101-13
Port test, UART cntrl. signal interrupt failure
1101-03
Port test, address line fault
1101-14
Port test, DRVR/RCVR data failure
1101-04
Port test, data line fault
1109-01
Clock register initialization failure
1101-05
Port test, UART cntrl. signal failure
1109-02
Clock register rollover failure
1101-06
Port test, UART THRE bit failure
1109-03
Clock reset failure
1101-07
Port test, UART Dta RDY bit failure
1109-04
Input line or clock failure
1101-08
Port test, UART TX/RX buffer failure
1109-05
Address line fault
1101-09
Port test, interrupt circuit failure
1109-06
Data line fault
1101-10
Port test, COM1 set to invalid INT
1150-xx
Comm port setup error (run Setup)
1101-11
Port test, COM2 set to invalid INT
--
--