3M 10700 Manual De Usuario
14
Installation and Setup
(Continued)
1.
Read and remove safety tag from pneumatic
"On/Off" valve.
"On/Off" valve.
2.
Connect the main air supply line to the inlet
side of the On/Off valve using the barbed
fitting and hose clamp provided. The
customer supplied air hose
(8 mm [5/16 inches] Inner Diameter) must be
clamped tightly to the barbed fitting.
side of the On/Off valve using the barbed
fitting and hose clamp provided. The
customer supplied air hose
(8 mm [5/16 inches] Inner Diameter) must be
clamped tightly to the barbed fitting.
If another type of connector is desired, the
barbed fitting can be removed and replaced
with the desired 1/4-18 NPT threaded
connector.
barbed fitting can be removed and replaced
with the desired 1/4-18 NPT threaded
connector.
Always turn the air valve Off when the air
supply line is being connected or
disconnected.
supply line is being connected or
disconnected.
3.
Turn the air supply on by turning the air On/Off
valve to On.
valve to On.
Note – The air valve has provisions for lock
out/tag out according to plant regulations.
out/tag out according to plant regulations.
4.
Raise the upper drive assembly to full Up position
by turning the drive assembly raising switch
clockwise.
by turning the drive assembly raising switch
clockwise.
PNEUMATIC CONNECTION
Note: A precision regulator is used to balance
the top drive assembly. Due to the self-
relieving feature of this regulator, a small
amount of air continually vents to the atmo-
sphere. This is normal and amounts to
approximately 3 liter/min. [0.1 SCFM].
the top drive assembly. Due to the self-
relieving feature of this regulator, a small
amount of air continually vents to the atmo-
sphere. This is normal and amounts to
approximately 3 liter/min. [0.1 SCFM].
•
To reduce the risk associated with impact
hazards:
−
Always use appropriate supporting means
when working under the upper drive
assembly
assembly
WARNING
The case sealer requires a 5.2 bar gauge
pressure 110 liter/min [75 PSIG], @ 21°C, 1.01
bar [3.75 SCFM] compressed air supply. As
shown in Figure 3-1, an on/off valve, pressure
regulator, and filter are provided to service the air
supply.
pressure 110 liter/min [75 PSIG], @ 21°C, 1.01
bar [3.75 SCFM] compressed air supply. As
shown in Figure 3-1, an on/off valve, pressure
regulator, and filter are provided to service the air
supply.
Important: Use care when working with
compressed air.
compressed air.