HP (Hewlett-Packard) 5697-1697 Manual De Usuario
NOTE:
It can take up to 10 minutes for the
component to display good status.
•
Observe the disk status indicators (
). The green indicator should be on or flashing.
•
Verify the following using HP P6000 Command
View:
View:
◦
Navigate back to the component and verify
the operational state. It should be
(Good).
◦
Ensure that the disk drive is running the correct
firmware. Record the Model number and the
Firmware version of the disk (
firmware. Record the Model number and the
Firmware version of the disk (
). Compare the firmware version with the
supported disk drive firmware in the HP P6000
Enterprise Virtual Array Disk Drive Firmware
Support document, which is available at the
following website:
Enterprise Virtual Array Disk Drive Firmware
Support document, which is available at the
following website:
Click Disk Storage Systems under Storage,
and then select your product under
P6000/EVA Disk Arrays.
and then select your product under
P6000/EVA Disk Arrays.
If the disk is running an unsupported version
of firmware, download the firmware from the
following website and install it using the
instructions included with the firmware file. Do
not add the disk to a disk group if it is running
an unsupported firmware version.
of firmware, download the firmware from the
following website and install it using the
instructions included with the firmware file. Do
not add the disk to a disk group if it is running
an unsupported firmware version.
NOTE:
When downloading the
firmware, use the disk drive model
number to locate the correct firmware
file. If you have difficulty locating the
firmware, contact your HP-authorized
service representative for assistance.
number to locate the correct firmware
file. If you have difficulty locating the
firmware, contact your HP-authorized
service representative for assistance.
Figure 13 Verifying model number and firmware
version
version
Adding the disk to a disk group
After replacing the disk drive, add the disk to a disk
group. The disk is typically added back into its original
disk group.
1.
group. The disk is typically added back into its original
disk group.
1.
In the navigation pane, select Storage
system
system
→Hardware→Disk Enclosure→Bay.
2.
In the content pane, select the Disk Drive tab.
3.
Click Group to initiate the process for adding the
disk to a disk group.
disk to a disk group.
Operation Successful
is displayed
indicating the disk is now grouped and leveling
has been initiated. The storage system begins
immediately using the disk.
has been initiated. The storage system begins
immediately using the disk.
NOTE:
If the Device Addition Policy is set to
automatic, the disk is automatically added to a
disk group. In this case, the Group option will
not be available.
disk group. In this case, the Group option will
not be available.
Returning the failed component
Follow the return instructions provided with the new
component.
component.
Documentation feedback
HP is committed to providing documentation that meets
your needs. To help us improve the documentation,
send any errors, suggestions, or comments to
Documentation Feedback (
your needs. To help us improve the documentation,
send any errors, suggestions, or comments to
Documentation Feedback (
).
Include the document title and part number, version
number, or the URL when submitting your feedback.
number, or the URL when submitting your feedback.
Page 6