Graco 3A0415D Manual De Usuario

The discharge period (Time) and/or lubrication 
canister size (Volume) can only be changed 
when a new lubrication canister is attached. If 
settings must be changed during current oper-
ation; i.e., after discharge was started, you 
must attach a new, completely filled lubrication 
canister and a new battery  pack.

Changing settings during operation interferes 
with the controls and monitoring electronics; 
making it impossible to guarantee precise 
lubrication.

Always use a new, completely full 
lubrication canister and new battery  pack 
after each setting change. Never use a 
partially empty lubrication canister or old 
batteries.

•

Before installing the lubricator, the lubrica-
tion points and any extensions must be 
adequately pre-lubricated with the same 
lubricant contained in the lubricator. A 400 
gram lubricant cartridge for grease guns is 
available from Graco. See Parts, page 16 
for a complete list of available lubricant car-
tridges. 

•

Install one lubricator per lubrication point.

•

When oil is used for lubrication, a 
non-return valve (oil throttle) must be 
installed. This will prevent oil leakage from 
the lubricator. An oil throttle, part number 
124102 is available from Graco. See Parts, 
page 16.

•

An oil-filled lubricator must be installed ver-
tically (outlet down). 

•

For horizontal mounting a bracket clip must 
be used to hold the lubricator in place. A 
horizontal clip bracket part number 124086 
is available from Graco. See Parts, page 16

•

For vertical installations always use a sup-
port adapter part number 124105 is avail-
able from Graco. See Parts, page 16.

•

The grease nozzle of the lubricator has a 
npt 1/4 inch male thread. If your application 
has a different thread you may need to use 
an adapter. See Parts, page 16 for a com-
plete list of available adapters. 

•

Do not overtighten the plastic thread of the 
lubricator.

•

For all metal to metal connections (i.e., 
extensions, reducers, etc.) make sure to 

use LOCTITE

®

 243* (semi-tight screw lock-

ing).

Refer to F

. 6 for examples of correct and 

incorrect direct mounting installations.