Cabletron Systems SSIM-H2-02 Manual De Usuario

SSIM-H2-02 Fast Ethernet - Translational Switch SmartStack Interface Module Installation and User Guide

Installation

The console will display the download activity while the software is transferred 
over the network by counting received blocks. When the software has been 
transferred, you will see the following messages:

Network download complete. Now transferring to TS 

Module(s), please wait...

Download of TS firmware complete - TS module(s) being 

reinitialized...

➽

Warning: If you use Telnet as a manager console, download activity will not be 
displayed.

The software image is then programmed into the FLASH memory on the module. 
The software image remains in memory until it is replaced. When the software 
installation is complete, the module is started for normal operation, and the 
following message is displayed:

Press <RETURN> to continue...

➽

Note: Remember that new module software is active immediately after it is 
downloaded, but to activate the module’s software you must restart the switch.

1. From the main menu, select Download

→

→

→

→

Upload. 

2. Select Serial Link Download. 

3. Select TS Firmware Download.

4. Using your terminal software, transfer the software image to the SSIM-H2-02 

with the X-Modem protocol. The transfer may take several minutes, depending 
on your terminal emulator baud.

The software image is then programmed into the FLASH memory of the module, 
and will remain there until it is replaced. When the software installation is 
complete, the module is started for normal operation and the following message is 
displayed:

Press <RETURN> to continue...