Manualsbrain.com
  1. Manuales
  2. Marcas
  3. Cabletron Systems
  4. 04-0053-01
  5. Manual De Usuario

Cabletron Systems 04-0053-01 Manual De Usuario

Descargar
Página de 133
5-16   SmartSwitch ATM User Guide
Soft PVC and PVP Connections
  Virtual Ports and Static Connections
3.
Use the 
add spvcaddress
 command on the target switch to specify the target port and ATM address.
SmartSwitch # add spvcaddress
PortNumber()                              : 6b3 
— Port on target switch
AtmAddress()                              : 22:22:22:22:22:22:22:22:22:22:22:22:22:22:22:22:22:22:22:22
Added SPVC Address successfully.
SmartSwitch #
Note
Both soft PVCs and Soft PVPs use the 
add spvcaddress
 command to specify the 
target switch’s target ATM address. There is no separate “
add spvpaddress
” 
command.
4.
Use the 
show spvcaddress
 command to see the soft PVP port and ATM address on the target switch:
SmartSwitch # show spvcaddress
PortNumber(ALL)                           :
TargetAddress()                           :
Port          SPVC Target Address
================================================================================
6B3         22:22:22:22:22:22:22:22:22:22:22:22:22:22:22:22:22:22:22:22
Total number of SPVC Addresses = 1
SmartSwitch # 
5.
On the source switch, use the 
add trafficdescriptor
 command to create traffic descriptors for the 
forward and reverse directions of the connection (See Section 5.1.1for information about traffic 
descriptors).
6.
On the source switch, use the 
add spvp
 command to create the soft PVP connection between the two 
switches:
SmartSwitch # add spvp
PortNumber()                              : 7a1 
— Port on source switch
SourceVpi(0)                              : 3
DestinationSelectType(REQUIRED)           :     
— See note below
DestinationVPI(0)                         : 3   
— 
We use VPI= 3
TargetAddress()                           : 22:22:22:22:22:22:22:22:22:22:22:22:22:22:22:22:22:22:22:22
TransmitTrafficDescriptorIndex()          : 3
ReceiveTrafficDescriptorIndex()           : 3
RetryInterval(10000)                      :
RetryLimit(3)                             :
RetryThreshold(1)                         :
SmartSwitch # 
Note
The 
DestinationSelectType
 determines which vpi is used on the target switch. 
The possible settings are 
REQUIRED
 and 
ANY
. If 
DestinationSelectType 
is set to 
REQUIRED
, the specified target vpi is set at the target switch. If 
ANY
 is specified, the 
soft PVP uses the first available vpi it finds on the target switch. If 
ANY
 is specified, 
enter the 
show spvptraget
 command on the target switch to determine the vpi 
used.