Manualsbrain.com
  1. Manuales
  2. Marcas
  3. Lantronix
  4. XSENSO 21R2
  5. Manual De Usuario

Lantronix XSENSO 21R2 Manual De Usuario

Descargar
Página de 125
4: Installation of xSenso 21A2
xSenso User Guide
31
Table 4-4  Analog Input and Analog Output LEDs
Table 4-5  Ethernet LEDs
Reset Button
You can reset the xSenso to factory default settings, including clearing the network settings. The 
IP address, gateway, and netmask are set to 00s. 
To reset the unit to factory defaults:
1.
Place the end of a paper clip or similar object into the RST (reset) opening (see 
and press and hold down micro switch during a power cycle for a minimum of 25 seconds.
2.
Remove the paper clip to release the button. The unit will continue the boot process restoring 
it back to the original factory default settings.
LED
Color
ON
OFF
“X” on top of 
xSenso device 
(Diagnostic)
Orange
ORANGE ON - power present
ORANGE Blink - during boot process after power cycle or 
reset.  Also blink patterns represent error conditions:
Loss of Redundant Power: one slow blink followed by 
two fast blinks (repeat)
No Ethernet Link: two slow blinks followed by two fast 
blinks (repeat)
No IP Address: three slow blinks followed by three fast 
blinks (repeat)
No power
Analog Input 1
Green 
or 
Orange
Input Type (voltage or current)
GREEN represents 100mV, 1V or 10V input range is 
selected
ORANGE represents 20mA input range is selected
Input not utilized
Analog Input 2
Green 
or 
Orange
Input Type (voltage or current)
GREEN represents 100mV, 1V or 10V input range is 
selected
ORANGE represents 20mA input range is selected
Input not utilized
Analog Output 1
Green 
or 
Orange
Output Type (voltage or current)
GREEN represents 0-10V output range is selected
ORANGE represents 20mA output range is selected
Output not utlized.
Analog Output 2
Green 
or 
Orange
Output Type (voltage or current)
GREEN represents 0-10V output range is selected
ORANGE represents 20mA output range is selected
Output not utlized.
Ethernet LEDs
Description
Left (L)
GREEN ON - 100 Mbps link established
GREEN Blink - 100Mbps activity
AMBER ON - 10 Mbps link established
AMBER Blink - 10 Mbps activity
Right (R)
GREEN ON - Full duplex
OFF - Half duplex