Lantronix XSENSO 21R2 Manual De Usuario
xSenso User Guide
50
8:
Network Settings
The Network Settings show the status of the Ethernet interface/link and let you configure the
settings on the device. Interface settings are related to the configuration of the IP and related
protocols. Link settings are related to the physical link connection, which carries the IP traffic.
settings on the device. Interface settings are related to the configuration of the IP and related
protocols. Link settings are related to the physical link connection, which carries the IP traffic.
The xSenso contains one network interface. The Ethernet interface is also called interface 1 or
eth0.
eth0.
Notes:
Some settings require a reboot to take effect. These settings are noted below.
Wait a minimum of 10-20 seconds after rebooting the unit before attempting to make
any subsequent connections.
any subsequent connections.
The
blue text
in the XML command strings of this chapter are to be replaced with a
user-specified name.
Network Interface Settings
Table 8-1 Network
Interface Settings
Network Interface
Settings
Settings
Description
BOOTP Client
Select to turn On or Off. At boot up, after the physical link is up, the xSenso will
attempt to obtain IP settings from a BOOTP server.
attempt to obtain IP settings from a BOOTP server.
Note:
Overrides the configured IP address/mask, gateway, hostname, and
domain. When DHCP is Enabled, the system automatically uses DHCP,
regardless of whether BOOTP is Enabled. Changing this value requires you to
reboot the device.
regardless of whether BOOTP is Enabled. Changing this value requires you to
reboot the device.
DHCP Client
Select to turn On or Off. At boot up, after the physical link is up, the xSenso will
attempt to obtain IP settings from a DHCP server and will periodically renew
these settings with the server.
attempt to obtain IP settings from a DHCP server and will periodically renew
these settings with the server.
Note:
Overrides BOOTP, the configured IP address/mask, gateway,
hostname, and domain. Changing this value requires you to reboot the device.
Note:
Within WebManager, click Renew to renew the DHCP lease.
IP Address
Enter the static IP address to use for the interface. You may enter it alone or in
CIDR format.
CIDR format.
Note:
This setting will be used if Static IP is active (both DHCP and BOOTP
are Disabled). Changing this value requires you to reboot the device. When
DHCP or BOOTP is enabled, the xSenso tries to obtain an IP address from a
DHCP or BOOTP server. If it cannot, the xSenso generates and uses an Auto
IP address in the range of 169.254.xxx.xxx, with a network mask of
255.255.0.0.
DHCP or BOOTP is enabled, the xSenso tries to obtain an IP address from a
DHCP or BOOTP server. If it cannot, the xSenso generates and uses an Auto
IP address in the range of 169.254.xxx.xxx, with a network mask of
255.255.0.0.
Default Gateway
Enter the IP address of the router for this network.
Note:
This setting will be used if Static IP is active (both DHCP and BOOTP
are Disabled).