Lantronix XSENSO 21R2 Manual De Usuario



To configure DAQ Settings, go to the Setup tab/page and click DAQ Format in the menu.



To enter the DAQ Settings command level:  
enable -> config -> analog -> daqformat



Include in your file:  <configgroup name=”daq format”>

AOUT2 <value>

Writes Output 2 value.  

Value must have float format:  
[+/-]<digits>.<digits>

AOUT2 +10.0\r

SUBMITTED

xSenso 21A2

ROUT1

Reads Relay 1 current setting.

ROUT1\r

+1

xSenso 21R2

ROUT2

Reads Relay 2 current setting.

ROUT2\r

+0

xSenso 21R2

ROUT*

Reads all current relay settings.

ROUT*\r

+1     +0

xSenso 21R2

ROUT1 <0, 1, or 2>

Write Relay 1 setting:



0 to turn off relay



1 to turn on relay



2 to reset latched relay

ROUT1 1\r

SUBMITTED

xSenso 21R2

ROUT2 <0, 1, or 2>

Write Relay 2 setting:



0 to turn off relay



1 to turn on relay



2 to reset latched relay

ROUT2 0\r

SUBMITTED

xSenso 21R2

Select Uptime or Clock time type. If Timestamp is enabled, this selection applies. 
Uptime represents the time since the device has powered up. To use Clock time, 
first go to Clock settings to set it up.

Select whether to enable a time stamp to be placed before each sample value.

Select whether to enable an alphanumeric identifier to be placed before each 
sample value and optional timestamp.

Select whether ot enable the applicable unit to be placed after each sample value.

Enter an end character to place this character at the tail end of sample strings.  You 
may also delete field contents to remove the end character.