Cisco Systems N7KF248XT25EP1 Manual De Usuario
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
6-34
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-18634-01
Chapter 6 Managing the Device Hardware
EPLD Configuration
To confirm the EPLD upgrade, see the
Caution
Resetting the power disrupts any data traffic going through the affected modules. If you power cycle the
entire system, all data traffic going through the system at the time of the power cycling is disrupted. This
is not necessary for release 4.0(3) or later.
entire system, all data traffic going through the system at the time of the power cycling is disrupted. This
is not necessary for release 4.0(3) or later.
Note
As of release 4.0(3) or later, the system automatically loads the new power management EPLD after an
upgrade, so it is no longer necessary to reset the power for the module or system.
upgrade, so it is no longer necessary to reset the power for the module or system.
Upgrading EPLDs for the Active Supervisor Module
When you upgrade EPLDs on a system with only one supervisor module, data traffic on the device will
be affected when you reload the system after the upgrade. If you are upgrading EPLDs for a dual
supervisor system, you can upgrade the standby supervisor while the system is operational as explained
in the
be affected when you reload the system after the upgrade. If you are upgrading EPLDs for a dual
supervisor system, you can upgrade the standby supervisor while the system is operational as explained
in the
To upgrade EPLDs for the supervisor module in a system with a single supervisor module, follow these
steps:
steps:
Step 1
Determine the slot number for each module. The active supervisor is in either slot 5 or slot 6.
switch# show module
Mod Ports Module-Type Model Status
--- ----- -------------------------------- ------------------ ------------
1 48 10/100/1000 Mbps Ethernet Module N7K-N148GT-11 ok
3 32 10 Gbps Ethernet Module N7K-M132XP-12 ok
5 0 Supervisor module-1X N7K-SUP1 active
10 48 10/100/1000 Mbps Ethernet Module N7K-M148GT-11 ok
Mod Sw Hw World-Wide_name(s) (WWN)
--- -------------- ------ -------------------------------------------------
1 4.0(2) 0.503 --
3 4.0(2) 0.601 --
5 4.0(2) 0.900 --
10 4.0(2) 0.902 --
Mod MAC-Address(es) Serial-Num
--- -------------------------------------- ----------
1 00-19-07-6c-c0-6c to 00-19-07-6c-c0-a0 JAB11060144
3 00-1b-54-c1-33-98 to 00-1b-54-c1-33-bc JAB1152010K
5 00-1b-54-c1-16-18 to 00-1b-54-c1-16-20 JAB114902HF
10 00-1b-54-c1-07-88 to 00-1b-54-c1-07-bc JAB114501RW
* this terminal session
switch#
Step 2
Install the EPLDs by entering the install module slot_number epld url command.
switch# install module 5 epld bootflash:n7000-s1-epld.4.0.2.img
EPLD image file , built on Fri May 16 20:36:39 2008