Cisco Systems N7KF248XT25EP1 Manual De Usuario
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
2-8
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-18634-01
Chapter 2 Installing a Cisco Nexus 7010 Chassis
Installing the Chassis
Prerequisites for Installing the Chassis
Before you install the chassis, you must make sure that the following items are available for the
installation:
installation:
•
Data center ground is accessible where you are installing the Cisco Nexus 7010 chassis
•
Four-post, 19-inch, EIA rack or cabinet that includes such a rack
For more information on the rack or cabinet, see the
Warning
Stability hazard. The rack stabilizing mechanism must be in place, or the rack must be bolted to the
floor before you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip
over. Statement 1048
floor before you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip
over. Statement 1048
•
Bottom-support rails installed in the rack or cabinet—You must already have two bottom-support
rails attached to the lowest possible rack unit on the chassis.
rails attached to the lowest possible rack unit on the chassis.
For more information, see the
•
Cisco Nexus 7010 chassis and its components are accounted for and undamaged
For more information, see the
Required Tools and Equipment
You need the following tools and equipment to install the Cisco Nexus 7010 chassis:
•
Mechanical lift capable of lifting at least 550 lbs (250 kg)
•
No. 1 Phillips screwdriver
•
Bottom-support rails kit (shipped with the Cisco Nexus 7010 system accessory kit)
Part of this kit has already been used to install the bottom-support rails.
lists the items in
the rack-mount kit.
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
•
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
•
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest
component at the bottom of the rack.
component at the bottom of the rack.
•
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in
the rack.
the rack.
Statement 1006