Cisco Systems N7KF248XT25EP1 Manual De Usuario
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
2-16
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-18634-01
Chapter 2 Installing a Cisco Nexus 7010 Chassis
Installing and Formatting CompactFlash Cards
Figure 2-9
ESD Grounding Port on the Rear of the Cisco Nexus 7010 Chassis
Installing and Formatting CompactFlash Cards
Each supervisor module on a Cisco Nexus 7000 Series device is shipped with a CompactFlash card
installed in the LOG FLASH reader. The EXPANSION FLASH reader is left empty, but you can
optionally install a card in that reader. For the card to function with the reader, you must make sure that
it is either formatted for the reader before installing it or format it after installing it.
installed in the LOG FLASH reader. The EXPANSION FLASH reader is left empty, but you can
optionally install a card in that reader. For the card to function with the reader, you must make sure that
it is either formatted for the reader before installing it or format it after installing it.
Note
The LOG FLASH and EXPANSION FLASH readers require different formats for their cards.
To replace an installed CompactFlash card, see the
.
To install a CompactFlash card, follow these steps:
Step 1
Align the card with the slot for the CompactFlash reader slot labeled LOG FLASH or EXPANSION
FLASH as shown in
FLASH as shown in
. The grooves on the thin side of the card must begin on the end of the
card that goes into the reader first.
187226
ESD port