Cisco Systems WSC2960XR48FPSI Manual De Usuario
Purpose
Command or Action
Returns to global configuration mode.
end
Example:
Switch(config-if)#
end
Step 12
Repeat Steps 9 through 13 on the other configured trunk
interface on Switch A, and set the spanning-tree path cost
to 30 for VLANs 8, 9, and 10.
interface on Switch A, and set the spanning-tree path cost
to 30 for VLANs 8, 9, and 10.
Step 13
Returns to privileged EXEC mode.
exit
Example:
Switch(config)#
exit
Step 14
Verifies your entries. In the display, verify that the path
costs are set correctly for both trunk interfaces.
costs are set correctly for both trunk interfaces.
show running-config
Example:
Switch#
show running-config
Step 15
(Optional) Saves your entries in the configuration file.
copy running-config startup-config
Example:
Switch#
copy running-config startup-config
Step 16
Related Topics
Network Load Sharing Using STP Path Cost, on page 65
Configuration Examples for VLAN Trunking
Example: Configuring an IEEE 802.1Q Trunk
This example shows how to configure a port as an IEEE 802.1Q trunk. The example assumes that the neighbor
interface is configured to support IEEE 802.1Q trunking.
interface is configured to support IEEE 802.1Q trunking.
Switch#
configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#
Switch(config)#
interface gigabitethernet0/2
Switch(config-if)#
switchport mode dynamic desirable
Switch(config-if)#
switchport trunk encapsulation dot1q
Switch(config-if)#
end
Catalyst 2960-XR Switch VLAN Configuration Guide, Cisco IOS Release 15.0(2)EX1
80
OL-29440-01
Configuring VLAN Trunks
Configuration Examples for VLAN Trunking