Cisco Systems WSC2960X24PDL Manual De Usuario
Switch(config)#
monitor session 2 destination interface gigabitethernet1/0/1
Switch(config)#
end
Examples: Creating an RSPAN VLAN
This example shows how to create the RSPAN VLAN 901:
Switch(config)#
vlan 901
Switch(config-vlan)#
remote span
Switch(config-vlan)#
end
This example shows how to remove any existing RSPAN configuration for session 1, configure RSPAN
session 1 to monitor multiple source interfaces, and configure the destination as RSPAN VLAN 901:
session 1 to monitor multiple source interfaces, and configure the destination as RSPAN VLAN 901:
Switch(config)#
no monitor session 1
Switch(config)#
monitor session 1 source interface gigabitethernet1/0/1 tx
Switch(config)#
monitor session 1 source interface gigabitethernet1/0/2 rx
Switch(config)#
monitor session 1 source interface port-channel 2
Switch(config)#
monitor session 1 destination remote vlan 901
Switch(config)#
end
This example shows how to remove any existing configuration on RSPAN session 2, configure RSPAN
session 2 to monitor traffic received on trunk port 2, and send traffic for only VLANs 1 through 5 and 9 to
destination RSPAN VLAN 902:
session 2 to monitor traffic received on trunk port 2, and send traffic for only VLANs 1 through 5 and 9 to
destination RSPAN VLAN 902:
Switch(config)#
no monitor session 2
Switch(config)#
monitor session 2 source interface gigabitethernet1/0/2 rx
Switch(config)#
monitor session 2 filter vlan 1 - 5 , 9
Switch(config)#
monitor session 2 destination remote vlan 902
Switch(config)#
end
This example shows how to configure VLAN 901 as the source remote VLAN and port 1 as the destination
interface:
interface:
Switch(config)#
monitor session 1 source remote vlan 901
Switch(config)#
monitor session 1 destination interface gigabitethernet2/0/1
Switch(config)#
end
This example shows how to configure VLAN 901 as the source remote VLAN in RSPAN session 2, to
configure Gigabit Ethernet source port 2 as the destination interface, and to enable forwarding of incoming
traffic on the interface with VLAN 6 as the default receiving VLAN:
configure Gigabit Ethernet source port 2 as the destination interface, and to enable forwarding of incoming
traffic on the interface with VLAN 6 as the default receiving VLAN:
Switch(config)#
monitor session 2 source remote vlan 901
Switch(config)#
monitor session 2 destination interface gigabitethernet1/0/2 ingress vlan 6
Switch(config)#
end
Feature History and Information for SPAN and RSPAN
Modification
Release
Switch Port Analyzer (SPAN):
Allows monitoring of switch traffic
on a port or VLAN using a
sniffer/analyzer or RMON probe.
Allows monitoring of switch traffic
on a port or VLAN using a
sniffer/analyzer or RMON probe.
This feature was introduced.
Cisco IOS 15.0(2)EX
Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX
OL-29044-01
97
Configuring SPAN and RSPAN
Examples: Creating an RSPAN VLAN