Cisco Systems WSC2960X24PDL Manual De Usuario
Purpose
Command or Action
Specifies the characteristics of the source port (monitored port) and SPAN
session.
session.
monitor session session_number source
interface interface-id
interface interface-id
Step 3
Example:
Switch(config)#
monitor session 2
• For session_number, the range is 1 to 66.
• For interface-id, specify the source port to monitor. The interface
specified must already be configured as a trunk port.
source interface gigabitethernet1/0/2
rx
rx
Limits the SPAN source traffic to specific VLANs.
monitor session session_number filter vlan
vlan-id [, | -]
vlan-id [, | -]
Step 4
• For session_number, enter the session number specified in Step 3.
Example:
Switch(config)#
monitor session 2
filter vlan 1 - 5 , 9
• For vlan-id, the range is 1 to 4094.
• (Optional) Use a comma (,) to specify a series of VLANs, or use a
hyphen (-) to specify a range of VLANs. Enter a space before and
after the comma; enter a space before and after the hyphen.
after the comma; enter a space before and after the hyphen.
Specifies the SPAN session and the destination port (monitoring port).
monitor session session_number destination
{interface interface-id [, | -] [encapsulation
replicate]}
{interface interface-id [, | -] [encapsulation
replicate]}
Step 5
• For session_number, specify the session number entered in Step 3.
Example:
Switch(config)#
monitor session 2
• For interface-id, specify the destination port. The destination
interface must be a physical port; it cannot be an EtherChannel, and
it cannot be a VLAN.
it cannot be a VLAN.
destination interface
gigabitethernet1/0/1
gigabitethernet1/0/1
• (Optional) [, | -] Specifies a series or range of interfaces. Enter a
space before and after the comma; enter a space before and after
the hyphen.
the hyphen.
• (Optional) encapsulation replicate specifies that the destination
interface replicates the source interface encapsulation method. If
not selected, the default is to send packets in native form (untagged).
not selected, the default is to send packets in native form (untagged).
Returns to privileged EXEC mode.
end
Example:
Switch(config)#
end
Step 6
Configuring a VLAN as an RSPAN VLAN
First create a new VLAN to be the RSPAN VLAN for the RSPAN session.
Beginning in privileged EXEC mode, follow these steps to create a new VLAN, then configure it to be the
RSPAN VLAN for the RSPAN session.
RSPAN VLAN for the RSPAN session.
Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX
OL-29044-01
83
Configuring SPAN and RSPAN
Configuring a VLAN as an RSPAN VLAN