Cisco Systems N6000 Manual De Usuario

S e n d d o c u m e n t a t i o n c o m m e n t s t o n e x u s 5 k d o c s @ c i s c o . c o m .

4-3

Cisco Nexus 6000 Series Hardware Installation Guide

OL-15902-01

Chapter 4 Replacing Components

Replacing Modules

Installing a LEM

To install a LEM in a Cisco Nexus 6004 chassis, follow these steps:

Step 1

Insert the LEM into the slot and make sure it is firmly installed.

Step 2

The LEM will auto power on if the poweroff command was not executed earlier on this slot. Otherwise
no poweroff module <x> will power it on.

If the following error message is observed, remove and reinsert the LEM as per guidelines:

2013 Feb 21 23:05:17 switch %$ VDC-1 %$ %USER-2-SYSTEM_MSG: Module 5 might not have been

seated properly. Please remove and re-insert the module.

If the error persists beyond 3 attempts, contact customer support.

Replacing Modules

This section includes the following topics:

•

•

Removing a Module

To remove a module from a Cisco Nexus 6004 chassis, follow these steps:

Step 1

Shut all the ports on the module

Step 2

Poweroff the module using the poweroff module <x> command.

Step 3

Physically remove the module.

Installing a Module

To install a module in a Cisco Nexus 6004 chassis, follow these steps:

Step 1

Insert the module into the slot and make sure it is firmly installed.

Step 2

Power on the moddule using the command no poweroff module <x>

Step 3

Bring up the ports on the module by issuing ‘no shut’ on the interfaces of the module