Cisco Systems WSC4500X16SFP Manual De Usuario
9-18
Software Configuration Guide—Release 12.2(25)EWA
OL-7659-03
Chapter 9 Configuring Switches with Web-Based Tools
Configuring and Using the Network Assistant
!
!
!
line con 0
password cna
login
stopbits 1
line vty 0 4
password cna
login
line vty 5 15
password cna
login
!
!
end
Switch#
Configuring Network Assistant in a Networked Switch in Cluster Mode
To configure Network Assistant on a networked switch in cluster mode, perform this task on the switch:
Command
Purpose
Step 1
Switch# configure terminal
Enters global configuration mode.
Step 2
Switch(config)# enable password
name
Enables password protection of configuration mode.
Step 3
Switch(config)# vtp domain
name
Creates a VTP domain to manage VLANs and names.
Step 4
Switch(config)# cluster run
Launches the cluster on the cluster commander.
Step 5
Switch(config)# cluster enable
cluster_name
Makes the switch the cluster commander.
Step 6
Switch(config)# vlan
vlan_id
Creates a VLAN.
Step 7
Switch(config-vlan)# interface {vlan
vlan_ID |
{fastethernet | gigabitethernet}
slot/interface
|
Port-channel
number}
Selects the interface that will connect to your CNA-enabled
PC.
PC.
Step 8
Switch(config-if)# switchport access vlan
vlan_id
Enables the physical port to be in the specified VLAN.
Step 9
Switch(config-if)# interface {vlan
vlan_ID |
slot/interface
|
Port-channel
number}
Select the VLAN instance for configuration.
Step 10
Switch(config-if)# ip address
ip_address
Assigns an IP address to the SVI.
Step 11
Switch(config-if)# no shut
Enables the interface.
Step 12
Switch(config-if)# ip http server
Starts the HTTP server so that Network Assistant can talk to the
switch.
switch.
Step 13
Switch(config)# ip http secure-server
(Optionally) Enables the switch to accept HTTPS connections
from Network Assistant.
from Network Assistant.
Step 14
Switch(config)# ip route
a.b.c
Establishes the route to the default router, usually supplied by
the local Internet Provider.
the local Internet Provider.
Note
This line represents the only difference between the
configuration for a standalone and a networked
switch.
configuration for a standalone and a networked
switch.
Step 15
Switch(config)# line con 0
Select the console port to perform the configuration.