Cisco Systems WSC4500X16SFP Manual De Usuario

You can create a new SmartPort macro or use an existing macro as a template to create a new macro that 
is specific to your application. After you create the macro, you can apply it to an interface or a range of 
interfaces.

This section includes information about these topics:

This section illustrates the default configurations for the four supported macros. These macros can only 
be viewed and applied; they cannot be modified by the user.

This is the example for the cisco-desktop macro:

# Basic interface - Enable data VLAN only

# Recommended value for access vlan (AVID) should not be 1

switchport access vlan $AVID

switchport mode access

# Enable port security limiting port to a single

# MAC address -- that of desktop

switchport port-security

# Ensure port-security age is greater than one minute

# and use inactivity timer

# “Port-security maximum 1” is the default and will not

# Show up in the config

switchport port-security violation restrict

switchport port-security aging time 2

switchport port-security aging type inactivity

# Configure port as an edge network port

spanning-tree portfast

spanning-tree bpduguard enable

This is the example for the cisco-phone macro:

# VoIP enabled interface - Enable data VLAN

# and voice VLAN (VVID)

# Recommended value for access vlan (AVID) should not be 1\

switchport access vlan $AVID

switchport mode access

# Update the Voice VLAN (VVID) value which should be

# different from data VLAN