Cisco Systems WSC4500X16SFP Manual De Usuario
17-17
Software Configuration Guide—Release 12.2(25)SG
OL-7659-03
Chapter 17 Configuring IGMP Snooping and Filtering
Configuring IGMP Filtering
Default IGMP Filtering Configuration
shows the default IGMP filtering configuration.
Configuring IGMP Profiles
To configure an IGMP profile and to enter IGMP profile configuration mode, use the ip igmp profile
global configuration command. From the IGMP profile configuration mode, you can specify the
parameters of the IGMP profile to be used for filtering IGMP join requests from a port. When you are
in IGMP profile configuration mode, you can create the profile using these commands:
global configuration command. From the IGMP profile configuration mode, you can specify the
parameters of the IGMP profile to be used for filtering IGMP join requests from a port. When you are
in IGMP profile configuration mode, you can create the profile using these commands:
•
deny: Specifies that matching addresses are denied; this is the default condition.
•
exit: Exits from igmp-profile configuration mode.
•
no: Negates a command or sets its defaults.
•
permit: Specifies that matching addresses are permitted.
•
range: Specifies a range of IP addresses for the profile. You can enter a single IP address or a range
with starting and ending addresses.
with starting and ending addresses.
By default, no IGMP profiles are configured. When a profile is configured with neither the permit nor
the deny keyword, the default is to deny access to the range of IP addresses.
the deny keyword, the default is to deny access to the range of IP addresses.
To create an IGMP profile for a port, perform this task:
Table 17-2
Default IGMP Filtering Settings
Feature
Default Setting
IGMP filters
No filtering
IGMP maximum number of IGMP groups
No limit
IGMP profiles
None defined
Command
Purpose
Step 1
Switch# configure terminal
Enters global configuration mode.
Step 2
Switch(config)# ip igmp profile
profile
number
Enters IGMP profile configuration mode
,
and assigns a
number to the profile you are configuring. The range is from
1 to 4,294,967,295.
1 to 4,294,967,295.
Step 3
Switch(config-igmp-profile)# permit | deny
(Optional) Sets the action to permit or deny access to the IP
multicast address. If no action is configured, the default for
the profile is to deny access.
multicast address. If no action is configured, the default for
the profile is to deny access.
Step 4
Switch(config-igmp-profile)# range
ip
multicast address
Enters the IP multicast address or range of IP multicast
addresses to which access is being controlled. If entering a
range, enter the low IP multicast address, a space, and the
high IP multicast address.
addresses to which access is being controlled. If entering a
range, enter the low IP multicast address, a space, and the
high IP multicast address.
You can use the range command multiple times to enter
multiple addresses or ranges of addresses.
multiple addresses or ranges of addresses.
Step 5
Switch(config-igmp-profile)# end
Returns to privileged EXEC mode.