Cisco Systems WSC4500X16SFP Manual De Usuario
31-14
Software Configuration Guide—Release 12.2(25)SG
OL-7659-03
Chapter 31 Configuring DHCP Snooping and IP Source Guard
Displaying IP Source Binding Information
•
This example shows displayed PVACLs for a port with multiple bindings configured for an IP/MAC
filtering:
filtering:
Interface Filter-type Filter-mode IP-address Mac-address Vlan
--------- ----------- ----------- --------------- -------------- ---------
fa6/4 ip-mac active 10.0.0.2 aaaa.bbbb.cccc 10
fa6/4 ip-mac active 11.0.0.1 aaaa.bbbb.cccd 11
fa6/4 ip-mac active deny-all deny-all 12-20
•
This example shows displayed PVACLs for a port configured for IP/MAC filtering but not for port
security:
security:
Interface Filter-type Filter-mode IP-address Mac-address Vlan
--------- ----------- ----------- --------------- -------------- ---------
fa6/5 ip-mac active 10.0.0.3 permit-all 10
fa6/5 ip-mac active deny-all permit-all 11-20
Note
The MAC filter shows permit-all because port security is not enabled, so the MAC filter
cannot apply to the port/VLAN and is effectively disabled. Always enable port security first.
cannot apply to the port/VLAN and is effectively disabled. Always enable port security first.
•
This example shows displayed error message when issuing the show ip verify source command on
a port that does not have an IP source filter mode configured:
a port that does not have an IP source filter mode configured:
IP Source Guard is not configured on the interface fa6/6.
You can also use the show ip verify source command to display all interfaces on the switch that have IP
source guard enabled:
source guard enabled:
Interface Filter-type Filter-mode IP-address Mac-address Vlan
--------- ----------- ----------- --------------- -------------- ---------
fa6/1 ip active 10.0.0.1 10
fa6/1 ip active deny-all 11-20
fa6/2 ip inactive-trust-port
fa6/3 ip inactive-no-snooping-vlan
fa6/4 ip-mac active 10.0.0.2 aaaa.bbbb.cccc 10
fa6/4 ip-mac active 11.0.0.1 aaaa.bbbb.cccd 11
fa6/4 ip-mac active deny-all deny-all 12-20
fa6/5 ip-mac active 10.0.0.3 permit-all 10
fa6/5 ip-mac active deny-all permit-all 11-20
Displaying IP Source Binding Information
You can display all IP source bindings configured on all interfaces on a switch using the
show ip source binding command.
show ip source binding command.
Switch# show ip source binding
MacAddress IpAddress Lease(sec) Type VLAN Interface
------------------ --------------- ---------- ------------- ---- --------------------
00:02:B3:3F:3B:99 55.5.5.2 6522 dhcp-snooping 10 FastEthernet6/10
00:00:00:0A:00:0B 11.0.0.1 infinite static 10 FastEthernet6/10
Switch#
describes the fields in the show ip source binding command output.