Cisco Systems N6KC600164P Manual De Usuario
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
8-13
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-18634-01
Chapter 8 Removal and Installation Procedures
Replacing a Cisco Nexus 7010 System Fan Tray During System Operations
Step 12
With one hand holding each side of the module, align the backside of the module to the slot guides in
the vacated slot, and slide the module part way into the slot.
the vacated slot, and slide the module part way into the slot.
Caution
To prevent ESD damage, avoid touching the electronic circuitry and prevent anything else from coming
in contact with the circuitry.
in contact with the circuitry.
Step 13
With one or both hands on the face of the module, push the module all the way into the slot until it seats
on the midplane connector. The EMI gasket will close the gap between this module and any module or
chassis edge that is immediately above the module that you just installed.
on the midplane connector. The EMI gasket will close the gap between this module and any module or
chassis edge that is immediately above the module that you just installed.
Step 14
Simultaneously push both ejector levers inward until they come in contact with the face of the module.
The captive screws should be aligned to their holes in the chassis.
The captive screws should be aligned to their holes in the chassis.
Step 15
Tighten the two captive screws on the fabric module to 69 N m (8 in-lb).
Replacing a Cisco Nexus 7010 System Fan Tray During System
Operations
Operations
The Cisco Nexus 7010 system has two system fan trays located on the upper backside of the chassis (see
).
Warning
Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
when servicing. Statement 1034
when servicing. Statement 1034
For instructions on replacing these fan trays, see the following sections:
•
•
Required Tools
You need a flat-blade or number 2 Phillips-head screwdriver to loosen or tighten the captive screws on
the fan tray.
the fan tray.
Replacing a Cisco Nexus 7010 System Fan Tray
The Cisco Nexus 7010 system fan tray is designed to be removed and replaced while the system is
operating, but you should replace the fan tray within a couple of minutes to maintain the designed system
airflow.
operating, but you should replace the fan tray within a couple of minutes to maintain the designed system
airflow.
Warning
When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the
fan blades completely stop before you remove the fan tray. Statement 258
fan blades completely stop before you remove the fan tray. Statement 258
To replace a Cisco Nexus 7010 system fan tray, follow these steps: