Cisco Systems N6KC600164P Manual De Usuario
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
D-1
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-18634-01
A P P E N D I X
D
Repacking the Cisco Nexus 7000 Series Device
for Shipment
for Shipment
This appendix describes how to repack the Cisco Nexus 7000 Series system for shipment. This appendix
includes the following sections:
includes the following sections:
•
•
Disconnecting the Cisco Nexus 7000 Series System
Before you can remove the Cisco Nexus 7000 Series system components and repack the system, you
must disconnect the system from the internet and the AC power source as explained in the following
topics:
must disconnect the system from the internet and the AC power source as explained in the following
topics:
•
•
•
Caution
When you are handling the Cisco Nexus 7000 Series device or switch components, you must follow the
ESD protocol at all times to prevent ESD damage. This protocol includes but is not limited to wearing
an ESD wrist strap that you connect to the earth ground in the data center building.
ESD protocol at all times to prevent ESD damage. This protocol includes but is not limited to wearing
an ESD wrist strap that you connect to the earth ground in the data center building.
Powering Down the Cisco Nexus 7000 Series System
To power down the Cisco Nexus 7000 Series system, turn the power switch on each power supply from
Power to STBY, and then disconnect the power cords to each power supply. The system is powered down
when the LEDs on each power supply are all off.
Power to STBY, and then disconnect the power cords to each power supply. The system is powered down
when the LEDs on each power supply are all off.
Disconnecting the System from the Console
To disconnect the system from the console, you must disconnect each interface cable that connects to
the management Ethernet (Mgmt Ethernet) and CMP Ethernet interfaces on each supervisor module.
You must also disconnect the cables and their adapters from the console.
the management Ethernet (Mgmt Ethernet) and CMP Ethernet interfaces on each supervisor module.
You must also disconnect the cables and their adapters from the console.