Cisco Systems 5500 Manual De Usuario

Each switching module (Prod # WS-X5013) contains a STATUS LED. When on, this LED indicates that 
the switching module is operational and is powered up. It does not necessarily mean that the interface 
ports are functional or enabled. 

The LEDs on the faceplate of the Ethernet switching module (10BaseT 24 Port) are described in 

 and shown in 

.

SLOT 1 
and 
SLOT 0

On

Supervisor Engine III only: The Flash PC Card SLOT 1 and SLOT 0 
LEDs light when their respective slot 1 and slot 0 Flash PC Card devices 
are accessed. 

100 Mbps

Green

The port is operating at 100 Mbps.

1000 Mbps Green

The port is operating at 1000 Mbps.

LINK

Green

The port is operational.

Orange

The link has been disabled by software.

Flashing
orange

The link is bad and has been disabled due to a hardware failure.

Off

No signal is detected.

STATUS

The switch performs a series of self-tests and diagnostic tests. 
If it passes all the tests, the status LED is green. 

If it fails any test, the status LED is red (or orange for a minor fault or if manually 
disabled).

Link

If the port is operational (a signal is detected), the LED is green.

If the link has been disabled by software, the LED is orange.

If the link is bad and has been disabled due to a hardware failure, the LED flashes 
orange.

If no signal is detected, the LED is off.

H3043