Cisco Systems 5000 Manual De Usuario
S e n d d o c u m e n t a t i o n c o m m e n t s t o n e x u s 5 k d o c s @ c i s c o . c o m .
3-10
Cisco Nexus 5500 Platform and Cisco Nexus 5000 Platform Hardware Installation Guide
OL-15902-01
Chapter 3 Connecting the Switch
Connecting to a Fibre Channel Port
Removing and Installing Cables into SFP Transceivers
Caution
To prevent damage to the fiber-optic cables, do not place more tension on them than the rated limit and
do not bend to a radius of less than 1 inch (2.54 cm) if there is no tension in the cable, or 2 inches
(5.08 cm) if there is tension in the cable.
do not bend to a radius of less than 1 inch (2.54 cm) if there is no tension in the cable, or 2 inches
(5.08 cm) if there is tension in the cable.
This section includes the following topics:
•
•
Installing a Cable into an SFP Transceiver
Caution
To prevent possible damage to the cable or transceiver, install the transceiver in the port before installing
the cable in the transceiver.
the cable in the transceiver.
To install a cable into a transceiver, follow these steps:
Step 1
Attach an ESD-preventive wrist strap and follow its instructions for use.
Step 2
Remove the dust cover from the connector on the cable.
Step 3
Remove the dust cover from the cable end of the transceiver.
Step 4
Align the cable connector with the transceiver and insert the connector into the transceiver until it clicks
into place. (See
into place. (See
).
Figure 3-4
Connecting the LC-Type Cable to a Fibre Channel Port
Caution
If the cable does not install easily, ensure that it is correctly positioned before continuing.
LC plug
SFP module
91681