Cisco Systems N7KF248XT25E Manual De Usuario
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
8-15
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-18634-01
Chapter 8 Removal and Installation Procedures
Replacing a CompactFlash Card
To replace a Cisco Nexus 7010 fabric fan tray, follow these steps:
Step 1
Place an antistatic mat or antistatic foam where you can place the fan trays.
Choose a place that prevents damage to the module while it is outside the chassis.
Step 2
Place the replacement fan tray on the antistatic mat or antistatic foam.
Step 3
Loosen the two captive screws on the fabric fan tray that you are replacing by turning them
counterclockwise until they are free of the chassis.
counterclockwise until they are free of the chassis.
Step 4
Grasp the fan assembly handle with one hand, pull the fan tray out of its slot on the chassis, and place
the fan tray on an antistatic pad or antistatic foam.
the fan tray on an antistatic pad or antistatic foam.
If the fan tray power connector does not easily unseat from the backplane, rock it gently.
Step 5
Grasp the handle for the replacement fan tray in one hand and orient it so that the side with two captive
screws is on the left. Place your other hand under the fan tray to support its weight.
screws is on the left. Place your other hand under the fan tray to support its weight.
Step 6
Align the fan tray to the open fabric fan tray slot. When it is aligned with the left and right chassis guides
for the fan module, push the fan module into the chassis until the power connector seats in the backplane
and the captive screws are aligned to their holes in the chassis.
for the fan module, push the fan module into the chassis until the power connector seats in the backplane
and the captive screws are aligned to their holes in the chassis.
Step 7
Tighten the captive screws to 8 in-lb.
Replacing a CompactFlash Card
You can replace a CompactFlash card in either flash memory reader on any supervisor module. The
replacement card must already be formatted for the reader or you must reformat the card after installing
it.
replacement card must already be formatted for the reader or you must reformat the card after installing
it.
Note
The LOG FLASH and EXPANSION FLASH readers require different formats for their cards.
To replace a CompactFlash card, follow these steps:
Step 1
Press the Eject Request button for the reader that has the card to be replaced.
Step 2
Wait for the reader LED to turn off.
•
If you are removing a log flash card, you will see the following message:
switch# 2008 Mar 15 10:00:00 switch %$ VDC-1 %$ %IDEHSD-2-UMOUNT:logflash:offline
•
If you are removing an expansion flash card, you will see the following message:
switch# 2008 Mar 15 10:00:00 switch %$ VDC-1 %$ %IDEHSD-2-UMOUNT:slot0:offline
Step 3
Press the Eject button next to the reader.
The reader ejects the card part way out of the slot.
Step 4
Remove the card from the reader.
Step 5
Align the replacement card to the CompactFlash reader slot as shown in
. The
grooves on the thin side of the card must begin on the end of the card that goes into the reader first.
Step 6
Push the card all the way into the reader.