Cisco Systems ASR 9000 Manual De Usuario
F I N A L D R A F T — C i s c o C o n f i d e n t i a l
3-35
Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
OL-17502-01
Chapter 3 Configuring General Router Features
Configuring the Management Ethernet Interface
Configuring the Management Ethernet Interface
To use the Management Ethernet interface for system management and remote communication, you must
configure an IP address and a subnet mask for the interface. If you want the interface to communicate
with devices on other networks (such as remote management stations or TFTP servers), you need to
configure a default route for the router.
configure an IP address and a subnet mask for the interface. If you want the interface to communicate
with devices on other networks (such as remote management stations or TFTP servers), you need to
configure a default route for the router.
Tip
For information on additional configuration options for the Management Ethernet interface, see Cisco
ASR 9000 Series Aggregation Services Router Interface and Hardware Component Configuration Guide.
ASR 9000 Series Aggregation Services Router Interface and Hardware Component Configuration Guide.
Prerequisites
To configure the Ethernet Management port for network communications, you must type the interface
network addresses and subnet mask. Consult your network administrator or system planner for this
information.
network addresses and subnet mask. Consult your network administrator or system planner for this
information.
SUMMARY STEPS
1.
configure
2.
interface MgmtEthrack/slot/CPU0/port
3.
ipv4 address ipv4-address subnet-mask
4.
no shutdown
5.
exit
6.
router static address-family ipv4 unicast 0.0.0.0/0 default-gateway
7.
commit
8.
end
9.
show interfaces MgmtEthrack/slot/CPU0/port