Cisco Systems 78-16019-02 Manual De Usuario

The CPU switch module provides a slot on the front panel that accommodates a CompactFlash card. You
can use the CompactFlash card for system image upgrades, FPGA image upgrades, statistics gathering,
and other file system applications.

The Cisco ONS 15530 supports redundant operation with dual CPU switch modules. The CPU switch
modules reside in slots 5 and 6, the sixth and seventh slots from the left as you face the chassis. For more
information about redundancy, see the

Cisco ONS 15530 ESP Hardware

.

Before starting up the Cisco ONS 15530, you should verify the following:

The system is set for the correct AC (or DC) power voltages.

Refer to the

 for correct power voltages.

The cables are connected to the system.

A console terminal is connected to the system.

Refer to the

for instructions.

When you start up the Cisco ONS 15530, the CLI (command-line interface) prompts you to enter the
initial configuration dialog. Answer no to this prompt:

Would you like to enter the initial dialog? [yes]: no

You see the following user EXEC prompt:

Switch>

You can now begin configuring the CPU switch module.

You can configure the Cisco ONS 15530 from a direct console connection to the console port or
remotely through its NME (network management Ethernet) port.

If you are using a direct console connection, configure your terminal emulation program for
9600 baud, 8 data bits, no parity, and 1 stop bit.

If you are using the NME port interface, you must assign an IP address to the interface
(fastethernet 0).

For interface configuration instructions, see the

.

For further details on configuring ports and lines for management access, refer to the