Cisco Systems 2975 Manual De Usuario
3
3
Running Express Setup
When you first set up the switch, you should use Express Setup to enter the initial IP information. Doing this enables the switch
to connect to local routers and the Internet. You can then access the switch through the IP address for further configuration.
to connect to local routers and the Internet. You can then access the switch through the IP address for further configuration.
You need this equipment to set up the switch:
•
A PC with Windows 2000 or XP installed
•
A web browser (Internet Explorer 6.0, 7.0, Firefox 1.5, 2.0, Windows Vista OS) with JavaScript enabled
•
A straight-through or crossover Category 5 Ethernet cable to connect your PC to the switch
Before running Express Setup, disable any pop-up blockers or proxy settings in your browser software and any wireless client
running on your PC.
running on your PC.
During Express Setup, the switch acts as a DHCP server. If your PC has a static IP address, change your PC settings before you
begin to temporarily use DHCP.
begin to temporarily use DHCP.
To run Express Setup:
Step 1
Make sure that nothing is connected to the switch.
Step 2
Power the switch by connecting the AC power cord to
the switch power supply and to a grounded AC outlet.
the switch power supply and to a grounded AC outlet.
Step 3
When the switch powers on, it begins the power-on self-test (POST). During POST, the LEDs blink while tests verify
that the switch functions properly.
that the switch functions properly.
Wait for the switch to complete POST, which can take several minutes.
Step 4
Verify that POST has completed by confirming that the SYST LED remains green. If the switch fails POST, the SYST
LED turns amber. See the “In Case of Difficulty” section on page 14 if your switch fails POST.
LED turns amber. See the “In Case of Difficulty” section on page 14 if your switch fails POST.
Step 5
Press and hold the Mode button for 3 seconds. When all
of the LEDs above the Mode button turn green, release
the Mode button.
of the LEDs above the Mode button turn green, release
the Mode button.
Step 6
If the LEDs above the Mode button blink after you press the button, release it. Blinking LEDs mean that the switch
is already configured and cannot go into Express Setup mode. For more information, see the “Resetting the Switch”
section on page 15.
is already configured and cannot go into Express Setup mode. For more information, see the “Resetting the Switch”
section on page 15.
Step 7
Verify that the switch is in Express Setup mode. Make sure that all LEDs above the Mode button are green. (On
some switch models, the RPS LED remains off.)
some switch models, the RPS LED remains off.)
Step 8
Connect a Category 5 Ethernet cable to any Ethernet
port on the switch front panel.
port on the switch front panel.
Connect the other end of the cable to the Ethernet port
on your PC.
on your PC.
Catalyst 2975G
Series PoE-48
205077
CONSOLE
DC INPUTS FOR REMO
TE
POWER SUPPL
Y
SPECIFIED IN
MANU
AL
STACK 1
STACK 2
205078
Catalyst 2975G
Series PoE-48
205079
Catalyst 2975G
Series PoE-48
205080